US Robotics USR803510 Uživatelská příručka stáhnout pdf (Strana 16)

 For all SIM card based operators

The network settings populate automatically for most SIM cards. Scroll down to the Network

Settings section and check the APN, Username, and Password fields. Update if necessary and

click Save changes. If the service plan requires a PIN code, scroll down to the PIN Settings

section, enable and enter the PIN code, and click Save changes.

Related Topics

Configuring the Base Unit

3G Connection Tab

Installing Expansion Cards

Gateway expansion cards are easy to install either during staging by a distributor or system integrator,

or in the field by a technician.

Expansion cards are designed to fit in one of two expansion slots accessed from the unit’s front or back

panels. In general, cards with antenna interfaces, such as the WLAN card, are installed in the back slot to

avoid interference with the 3G antennas on the front of the base unit.

To install an expansion card:

1. Make sure the unit is powered off.

2. Using a T6 Torx screwdriver, remove the three screws from the bottom plate on the front or

back panel, and remove the plate.

3. With the expansion card in your hand, make sure the English labelling for any external

interfaces, such WLAN Antenna or Serial Port, are facing up. In this orientation, the card

connector is also right facing.

Tip: Another way to determine the appropriate slot, is to look at the card connector. Cards with the

small connector are installed in the rear slot. Cards with the large connector are installed in the front

slot.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 157 158

Žádné komentáře

US Robotics USR803510 Uživatelská příručka Strana 16