US Robotics 56 K SOFTMODEM - COMMAND REFERENCE REV 1 Uživatelský manuál Strana 35

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 108
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 34
56K Softmodem
Command Reference
- 29
Table 3-39: N<value> Commands
\Q<value>—Local Flow Control Selection
Use this command to set the local flow control method. Result codes:
OK if <value> = 0—1, or 3.
ERROR if <value> does not equal 0—1, or 3.
Table 3-40: \Q<value> Commands
\R<value>—Ring Indicator Signal Off After Answer
This command is supported to ensure compatibility with communications
software that issues the \R0 command.
Result codes:
OK if <value> = 0.
ERROR if <value> does not equal 0.
Command Function
\N0 Buffer mode. No error control (same as &Q6).
\N1 Direct mode.
\N2 MNP or disconnect mode. The modem attempts to connect using MNP 2—4 error control proce-
dures. If this fails, the modem disconnects. This is also known as MNP reliable mode.
\N3 V.42, MNP, or buffered (default). The modem attempts to connect in V.42 error control mode. If
this fails, it will attempt to connect in MNP mode. If this also fails, the 56K Softmodem
connects
in buffer mode and continues operation. This is also known as V.42/MNP auto reliable mode
(same as &Q5).
\N4 V.42 or disconnect. The modem attempts to connect in V.42 error control mode. If this fails, the
modem disconnects.
\N5 V.42, MNP, or buffered (same as \N3).
\N7 V.42, MNP, or buffered (same as \N3).
Command Function
\Q0 Disables flow control (same as &K0).
\Q1 XON/XOFF software flow control (same as &K4).
\Q3 RTS/CTS to DTE (same as &K3) (default).
Zobrazit stránku 34
1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 107 108

Komentáře k této Příručce

Žádné komentáře