US Robotics USR8700 Instalační příručka stáhnout pdf (Strana 8)

English

2. Near the front of the tray is a spacer containing four screws. Squeeze the tabs together to remove the

spacer from the tray.

3. With the flat edge of the spacer up and the screws facing a flat surface (such as a table or desk top),

flex the sides of the spacer apart from each other to release the screws.

4. Make sure that the hard disk is a SATA disk. It should have a SATA connector similar to the following:

5. Slide the new hard disk into the tray (connector end down and toward the back of the tray), and fas-

ten the screws on the sides of the tray:

6. Slide the hard disk and tray back into the storage system until it snaps into place.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 35 36

Žádné komentáře

US Robotics USR8700 Instalační příručka Strana 8