US Robotics USR5462 Uživatelská příručka stáhnout pdf (Strana 64)

Troubleshooting

3. Then type ipconfig/renew.

D. The 10/100 LED does not light after a connection is made.

1. Check that the host computer and the 802.11g 54Mbps Router

are both powered on.

2. Be sure the network cable is connected to both devices.

3. Verify that Category 5 cable is used if you are operating at

100 Mbps, and that the length of any cable does not exceed

100 m (328 ft).

4. Check the network card connections.

5. The 10BASE-T/100BASE-TX port, network card, or cable may be

defective.

E. If wireless clients cannot access the network, check the

following:

1.Be sure the 802.11g 54Mbps Router and the wireless clients

are configured with the same Service Set ID (SSID).

2. If authentication or encryption are enabled, ensure that the

wireless clients are properly configured with the appropriate

authentication or encryption keys.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 77 78

Žádné komentáře

US Robotics USR5462 Uživatelská příručka Strana 64