US Robotics 56K PCI FAXMODEM - QUICK REV 1 Instalační příručka stáhnout pdf (Strana 12)

If AT is displayed in the Minicom window as you type and OK is displayed

after you press ENTER, the installation was successful.

AT is not displayed as you type and OK is not displayed after you press

ENTER, the installation was not successful; repeat the installation proce-

dure.

o If using X Windows, use Minicom through a shell window or use the dial-up pro-

gram (Kppp or equivalent).

a) Execute the Kppp program (or other dial-up program) from the Internet sub-

menu.

b) Within the Kppp program, click the Setup button, then the Device tab, and

then select U.S. Robotics V92 Fax PCI from the pull-down menu.

c) Click the Modem tab, then click the Query Modem button. About 15 sec-

onds later a window should appear with I-screen information from the

modem, indicating a successful installation.

If no information is displayed, the installation was not successful; repeat

the installation procedure.

My computer isn’t recognizing the modem.

Solution 1:

Ensure you have seated the modem completely into the PCI slot. The modem should be

perpendicular to the system board and flush against the rear of the case.

Solution 2:

1. Turn off the computer.

2. Physically remove the modem from the computer.

3. Follow "Step Two: Install the Modem Hardware" using a different PCI slot inside your

computer and repeat rest of the installation procedure.

My communications software does not recognize the modem.

Solution 1:

Your communications software may not function properly if any of the following are

true:

1 2 ... 7 8 9 10 11 12 13 14 15 16

Žádné komentáře

US Robotics 56K PCI FAXMODEM - QUICK REV 1 Instalační příručka Strana 12