US Robotics COURIER Uživatelský manuál Strana 186

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 308
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 185
U.S. Robotics I-modem Command Reference
Analog Synchronous Applications • Page 16-1
Chapter 16
Analog Synchronous Applications
This chapter applies to situations in which you want the I-modem to work with devices,
such as mainframe computers, that communicate using analog, synchronous
protocols.
The I-modem must be connected to a synchronous serial port.
Note These procedures do not apply to synchronous PPP calls.
There are two ways to operate the I-modem in analog synchronous mode:
¥ Dial Using V.25bis Software. ConÞgure the I-modem to enter synchronous mode when
you power it on. Then run communications software that uses the V.25bis protocol
to
control the dialing process.
¥ Dial Using AT Commands. ConÞgure the I-modem to dial out using AT commands and
then switch to synchronous mode once a connection is made.
Zobrazit stránku 185
1 2 ... 181 182 183 184 185 186 187 188 189 190 191 ... 307 308

Komentáře k této Příručce

Žádné komentáře